IR Remote for Bulkey No Touch sensor setup

Programmable parameters can be set via a dedicated IR remote.

Powered by a CR2032 Battery

Programming method (please see the full manual in “Downloads):
– the “*” button is pressed to enter the programming mode (the LED starts flashing quickly)
– enter the 4-digit access password for the specific sensor
– selection of a parameter to change:
o “>” for sensitivity parameter,
o “<” for hold time parameter.
– We select the value of the corresponding parameter from “0” to “9”.
– The “#” button is pressed
– The value of the corresponding parameter from “0” to “9” is confirmed.
– Press “Ok”.
If the entire series of entered data is correct, the LED goes out for 2 seconds.
It then displays the entered parameter value as:
– for value “0” – blinks slowly 10 times
– for value “1” – blinks slowly 1 time, and for 9 – blinks slowly 9 times, etc.
After that, it exits the programming mode – the LED lights up constantly.
If the password is not entered correctly or the parameter values are not entered equally or the exact sequence is not observed – the sensor exits the programming mode without changing the parameter. Then the LED starts to glow constantly.
Each time a signal is received from the remote, the LED lights up